trinityamps.com • View topic - Lightning Plates Corel Draw File

View unanswered posts | View active topics

Board index » On Stage » Lightning Strikes

All times are UTC - 5 hours [ DST ]

Lightning Plates Corel Draw File

Moderators: coco, J-Rock, bitsandvolts

Page 2 of 2

[ 23 posts ]

Go to page Previous 1, 2

Previous topic | Next topic

Author

Message

Post subject:

Posted: Fri Apr 15, 2005 10:49 pm

Experienced

Joined: Sun Mar 13, 2005 11:38 pm
Posts: 216
Location: Dallas, TX

Well, you can put the numbers along a 300 degree curve and use some function to cut them off the curve. I did it that way once, but couldn't figure it out again and needed to place the order ASAP, so I went to the faking it method.

_________________
--s2
www.s2amps.com
www.category5amps.com

Last edited by s2 on Sun Aug 07, 2005 9:04 pm, edited 1 time in total.

Top

Post subject:

Posted: Sat Apr 16, 2005 10:42 pm

Friend

Joined: Sun Mar 20, 2005 1:00 am
Posts: 13

I figured it out.. it's the rotation transformation tool.
thanks

Top

Post subject:

Posted: Sat Apr 16, 2005 10:43 pm

Friend

Joined: Sun Mar 20, 2005 1:00 am
Posts: 13

I figured it out.. it's the rotation transformation tool.
thanks

btw- I think I'm going to use 30 watt iron and put in two extra els -

Top

Page 2 of 2

[ 23 posts ]

Go to page Previous 1, 2

Board index » On Stage » Lightning Strikes

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 6 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum