trinityamps.com • View topic - Getting rid of the master

View unanswered posts | View active topics

Board index » On Stage » Lightning Strikes

All times are UTC - 5 hours [ DST ]

Getting rid of the master

Moderators: coco, J-Rock, bitsandvolts

Page 1 of 1

[ 3 posts ]

Previous topic | Next topic

Author

Message

JamesO

Post subject: Getting rid of the master

Posted: Sun Jul 22, 2007 5:05 pm

Experienced

Joined: Sat Jun 10, 2006 4:23 pm
Posts: 191

I'm interested in seeing what the amp's like without the master. I've been reading that it's more transparent. To remove the master, would I just disconnect the red and blue wires from the board? that run to it? If I wanted to keep the cut would I just route those two wires to the cut control instead? Blue goes to pin 3 of the cut control and red goes to pin 2?

Top

coco

Post subject:

Posted: Mon Jul 23, 2007 7:07 am

Holy Ghost

Joined: Sun Mar 13, 2005 4:10 pm
Posts: 7519
Location: Canada

Suggest you switch it out but if you are moving wires, you just need one send & one return to feed the cut. Same two wires that feed the master - moven them over to the cut. Follow the schematic.

_________________
Stephen
Web: www.trinityamps.com. Facebook: facebook.com/trinityamps. Twitter: @trinityamps

Top

JamesO

Post subject:

Posted: Mon Jul 23, 2007 1:09 pm

Experienced

Joined: Sat Jun 10, 2006 4:23 pm
Posts: 191

Thanks, Stephen. Thanks for the schematic reminder, too. I need to get into the habit of using them.

Top

Page 1 of 1

[ 3 posts ]

Board index » On Stage » Lightning Strikes

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 10 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum