Hi everyone: relatively simple question here. Looking at the picture layout provided, the following is shown; for the Input Jack picture looking from the rear is Ground (top tab i.e. closest to you) Switch (middle tab) and Hot is bottom tab. Is that correct? Assuming it is then.....
Looking at the picture component layout provided with the kit, the 1 M resistor goes across from Ground to Switch, according to the diagram, however with the manual the photo shows the 1 M resistor going from Hot to Switch, and other photo's in the forum show the 1 M resistor going from Ground to Hot.
Which one is the correct one, where does the 1 M resistor go? Ground to Hot tab (or Switch tab), or Hot to Switch tab?
Thanks in advance
Frank Mena
_________________ Cheers and Thanks
|