trinityamps.com

Trinity Amps Guitar Amp Forum
It is currently Tue Jul 16, 2024 7:45 am

View unanswered posts | View active topics


Board index » On Stage » Tweed

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
Chester
PostPosted: Mon Nov 23, 2009 10:06 am 
Offline
Friend
Friend

Joined: Sun Sep 27, 2009 10:10 am
Posts: 43
Hi,

I've just started this build. (Heaters, pilot lamp are wired, and some ground connections are made.)

I would like to ask how many of you made the optional V1 input as mentioned in the manual. You know, terminal strip with resistors at the base of V1, shielded cable to there from the inputs...

And, since I will be placing a switched pot in the position of the on/off switch, I'm looking for a way to center the pot in the hole. The hole for the switch is a little bit bigger than pot diameter. Any ideas ?

Thanks !
Top
 Profile  
 
joeyvelour
 Post subject:
PostPosted: Mon Nov 23, 2009 10:39 am 
Offline
Experienced
Experienced

Joined: Fri Mar 14, 2008 12:05 pm
Posts: 432
Location: Massachusetts
Take a look here...
viewtopic.php?t=1567

Scroll down and you should find a similar issue they have with the Triwatt switched pot :)

Joe G

_________________
Some assembly required,
Brain sold separately...
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » On Stage » Tweed

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 44 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group