I know a 5F1 is by no means a 5E3 (my 5E3 is orange and my 5F1 is black)but this seemed like the most natural place to post - I don't have an 18W) hence I'm posting here.
I'd like to install VVR (VRM) in my 5F1, going by the setup at the VRM Info thread in the resources section
I'm entirely new to the topic of Mosfets, is there any particular specs I should know so I won't end up buying the wrong one?
And are the values the same for any valve amp? (as in for 18W, 5E3, 5F1, ... (say P1, Firefly etc., JCM800, JTM45)
Also, a prticular question about the value in small type in the little grey blob. It says 6.2v on the line between the 100k 1W and the red B+ arrow, to the left underneath the 5R 2W resistor. I take it that's just a value you should get when measuring the voltage, not a plaece to put a component (what type of component would that be that only has a voltage rating but no spec'ed resistance or conductance)?
_________________ Sax or guitar? That's the question
|