Thanks Kurtlives...if I can find a spot for that board, I will do that
crédit surendettement. The chassis is 2.5" deep so I may use the side of the chassis near the cap can and mount the board.
Here's everything in place...I still haven't drilled mounting holes for the turret board..its just sitting on top of the standoffs. note that the tubes and controls are on the same side of the chassis. I have a Hall VVR that I will likely install (shown on far left). Also will have an indicator lamp to go next to it.
I have already seen this connection but I do not know too much. If anyone could teach me how it works.