trinityamps.com

Trinity Amps Guitar Amp Forum
It is currently Sat Nov 23, 2024 8:02 pm

View unanswered posts | View active topics


Board index » Back Stage » Dressing Room

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
ozzyatfrbrich
 Post subject: Question about arcing
PostPosted: Fri Jun 29, 2007 6:30 pm 
Offline
Friend
Friend

Joined: Fri May 27, 2005 8:00 pm
Posts: 33
Location: Richmond, VA USA
I am in the process of modifying a pre-drilled / punched steel chassis. I am adding a second output jack and impedance switch however; some of the connections will be very close to the rectifier, output and vibrato tube sockets. Some of the connections will be within 3/16â€
Top
 Profile  
 
coco
 Post subject:
PostPosted: Fri Aug 10, 2007 6:36 pm 
Offline
Holy Ghost
Holy Ghost
User avatar

Joined: Sun Mar 13, 2005 4:10 pm
Posts: 7519
Location: Canada
That's very close but I dont think you'll get arcing [unless you accidentally touch them both :shock: ].

I would be concerned that the tubes are too close to each other and will 'heat' one another.

_________________
Stephen
Web: www.trinityamps.com. Facebook: facebook.com/trinityamps. Twitter: @trinityamps
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Back Stage » Dressing Room

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 40 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group