Hi,
I've just got my first plexi kit and i was looking at the instructions and
photos on here but is there a picture of the underside of the turret board
so i can solder it up, also does it matter which way round it goes for a
combo is it obvious as i don't know what i'm doing yet.
When i wire the heaters up do i go from the tranny tag board to v1
or v5 i.e nearest the tranny,and when you daisy chain do you solder 2 pieces of wire on the heater and run the spare one along.
Sorry to go on but just want to make sure.
Thanks
|