trinityamps.com

hi this is the voltages of my sIII
the amp sound good the voltage seems close from the chart but a little bit smaler may be beacause of my B+ ( it's not hight )
all voltage taken from the board

wall voltage 230VAC
B+(w only rectifier) 415VDC
B+(w all tubes in ) 340VDC

V1
P1 134
P3 0.93
P6 135.6
P8 0.94

V2
P1 162
P3 1.55
P6 248
P8 161.5

V3
P1 200
P2 50
P3 70
P6 194
P8 70

V4/V5 ( same value take at one comon point of the board each time )
P3 10.7
P7 328
P9 318

V6
P1 293
P3 341
P7 293

could you tell me if this voltage looks correct for you ?

thanks

I'd say it's good. I'd be pretty happy with that.

_________________
Stephen
Web: www.trinityamps.com. Facebook: facebook.com/trinityamps. Twitter: @trinityamps

Those voltages all look good to me.


Oops, I see Stephen just answered already...

_________________
Great tones come in small glass jars!

ok thanks
they're good balanced !

they are below the chart ,but i have an idea about this:
i think it's beacause the primary of the PT is rated for 240 VAC with my wall at 230 that will provide a smaller B+

i have another question about the VRM
i read all the topic about the vrm and i dont understand wath is exactly the purpose of the vrm

it is to have a saturation of the power tubes at low volume like an attenuator ?

That's correct. Similar tone you get at high volume, but at low volume. Works well too. Information in the resourse section.

_________________
Stephen
Web: www.trinityamps.com. Facebook: facebook.com/trinityamps. Twitter: @trinityamps