Last year I sold my woodworking shop in Kirkland Lake, and bought some property in Timmins to re-establish my business. I purchased an empty metal structure (steel clad steel frame) that was just a shell, used for several years for cold storage.
Working very hard over the past several months, I am almost ready to start working again... maybe two more weeks of organizing and final touches. I purchased most of the equipment new, and since I sold my other shop turn key with all materials, hand tools, etc I had to start right from scratch.
Here is where I am as of this past weekend... will post a few more when its finally finished!
AJC
I did all my compressed air lines in 3/4" copper and I have many drops around the shop with water traps and shut offs. No more pulling lines all over the shop! My compressor is a 10 HP Ingersoll Rand. Very nice I must say! My 3 phase converter, and both the main panel and 3 phase panel are also in the compressor room.
![Image](http://i83.photobucket.com/albums/j307/ajcoholic/IMG_0456-1.jpg)
My clamps (40 3/4" pipe clamps, 40 Bessey K body clamps and 40 smaller C clamps - nothing MIC, all quality US made Jorgenson and Bessey) live on the mobile cart and the board fastened to the steel support - both sides are covered in clamps.. you can NEVER have enough clamps!
![Image](http://i83.photobucket.com/albums/j307/ajcoholic/IMG_0458.jpg)
My Omga (Italian) radial arm saw, and 8' fences both sides. Blades should be in this week for this.
![Image](http://i83.photobucket.com/albums/j307/ajcoholic/IMG_0459.jpg)
The saw stop industrial 10" (5 HP) table saw. This will be my workhorse saw, where I do a lot of various cutting/dadoes and rabbeting, etc. Right beside my big bench for convenience. Also I need yet to make the side and outfeed tables.
![Image](http://i83.photobucket.com/albums/j307/ajcoholic/IMG_0460.jpg)