dan_tramble wrote:
can I run the black (off the OT) to the negatives on the switch crafts' and run one green to one jack and a orange to the other and denote on the chasis which is 8 and 16?
If this is the case, do I cut, heat shrink the 4 ohm output?
Yes you can. In that case I wouldn't cut the 4 ohm wire too short. You might want to use it in the future. Just heat shrink the end and wrap it up. Of course you couldn't use both jacks at the same time.
I would wire both jacks to the impedance selector switch as shown in the layout, though. You might want to try the amp with a 4 ohm cabinet later on.