trinityamps.com

Has anyone installed an effects loop in their Trinity 18 watt? I’ve been looking at a couple of pre-made board kits from a couple of vendors online for ideas. The one thing I notice is it looks like the loop will only work on one channel, for instance the TMB channel if the loop is inserted between the treble pot and master volume. Does anyone have plans to build your own loop or should I just buy one of these kits?

It probably easier to buy a solid state one and install

But if your determined to make your own check this thread lots of good info

https://el34world.com/Forum/index.php?topic=10208.0

And yes it will be one channel or the other without some other changes

Thanks for the input. I figured it was one channel only without doing some rearranging of the P.I. inputs. I use the TMB channel the most anyway. The two boards I’ve looked at are Metro Amps and Mojotone. The Metro board has a trim pot and selectable line and pedal levels as well.

So I bought the Metro kit a couple of weeks ago. I’m hoping to get around to installing it next week.

Measure voltage at PI. Tap off at PI for Fx loop and adjust upstream Dropping resistor to bring PI back up to spec again.

_________________
Stephen
Web: www.trinityamps.com. Facebook: facebook.com/trinityamps. Twitter: @trinityamps

No. I did not but I really want to give it a try! I will let you know soon how the things are going on!

_________________
http://essay-editor.net/blog/category/how-to/page/5

Please write what your attempt to try was crowned with?

I'd also like to know more about building a fx loop into my 18w 6v6 custom. I understand one problem with plexi kind amps is that the signal is most likely too hot between the v2 and the PI for the effects in between?
But i'm hoping me reducing the overal voltage with VRM (half way now) would perhaps take care of the too-hot signal problem?