trinityamps.com

Quick question. I have gotten through the wiring of the transformers to the suggested AC voltage test.

When dialing up the power on the Variac to 119.9 I get the following
119.9 on the IEC and Indicator
5.8 Pins 2/8 V7
620vac pins 4/6 V7
6.88 4/5 V5 V6
6.88 4-5/9 V1,V2,V3,V4.

These are all higher than the manual test voltages. The Rectifier Voltage seems a good bit higher.

I am used to seeing higher voltages prior to tube install but these are the published test voltages w/ no tubes...

Do you think there is an issue or just a hot PT??

BTW I did clean out the trash before firing it up :-)

Any other observations or comments are welcomed..

Thanks,

The post presented me with a wealth of information, allowing me to broaden my horizons.
io games

It sounds like you are experiencing higher voltages than the manual states when testing your transformers. This could be due to a number of factors, including a more powerful transformer (PT) or a slight variation in measurements doodle jump. If you have cleaned before operation and tested carefully, this is likely just a normal difference due to component or measurement method variations.

The TC-15 Build AC Voltages Test question is discussed on the Lightning Strikes board under the On Stage section. The content is time-stamped to UTC - 5 hours (DST). For those interested in related games like Monkey Mart, staying updated on such technical discussions can be essential for troubleshooting.

Monkey Mart