trinityamps.com

Trinity Amps Guitar Amp Forum
It is currently Sat Nov 23, 2024 1:38 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Mon Mar 26, 2012 9:24 am 
Offline

Joined: Mon Mar 26, 2012 9:11 am
Posts: 2
I'm not a wiz when it comes to electronics but have been successful in building about 30 "Champ" kits and a few Marshall clones, a Brown Note and pedals. I'm finishing a Deluxe build and it sounds great. I am having difficulty as to which wires to connect to the B+ IN and OUT. More specifically - which wire from the standby switch and which wire from which filter cap? The instructions are a bit confusing (at least to a beginner like me). Thanks for your help.

Denny


Top
 Profile  
 
PostPosted: Sun Apr 08, 2012 11:36 pm 
Offline
Holy Ghost
Holy Ghost
User avatar

Joined: Sun Mar 13, 2005 4:10 pm
Posts: 7519
Location: Canada
the wire on the "output" side of the standby switch that goes to the board. Reomve it from the switch, move it to the OUT terminal on the VRM board and then put new wire from the standby switch to the VRM IN terminal.

_________________
Stephen
Web: www.trinityamps.com. Facebook: facebook.com/trinityamps. Twitter: @trinityamps


Top
 Profile  
 
PostPosted: Mon Apr 09, 2012 8:12 am 
Offline

Joined: Mon Mar 26, 2012 9:11 am
Posts: 2
Thank you VERY Much!!

Denny


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 20 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group