As a start, here's some general steps. Maybe you want to add some tips for a particular section.
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Build Turret / Eyelet Board
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Install the Hardware including power transformer, output transformer and the choke
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Install the turret or eyelet board
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Wire the tube heaters - don’t switch the heater wire polarity.
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Wire up the main power supply. Starting at the IEC connector
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Wire the Rectifier
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Connect the Board - make the connections from the turret board to the tubes.
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Connect the Board - make the connections from the turret board to the potentiometers.
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Wire up the input jacks - Use shielded wire
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Wire up the Output Transformer to the Output Jacks.
Double-check the wiring and the components.Trace or highlight the connections on a copy of the layout.
![Arrow :arrow:](./images/smilies/icon_arrow.gif)
Follow Power Up Sequence testing voltages as you proceed.