My kit came in the mail today, and one of the red wires on the power transformer has a jacket tear and the wire strands are cut and not touching. I'm guessing it was pinched in the package with a lot of pressure directly on that point of the wire.
![Image](https://i.postimg.cc/Tw8yP3yN/1.jpg)
![Image](https://i.postimg.cc/rsjzgGf7/2.jpg)
![Image](https://i.postimg.cc/90CrGgYG/3.jpg)
There was also an indent on another red wire in the same location, but the jacket wasn't ripped so hopefully the wire itself is in tact. That's the spot that I put heat shrink over in the first photo.
It's pretty far up the wire so I won't be able to just snip it at that point. What's the best way to go about this?
Thanks.