Page 69 - Triwatt Custom Lead Amp Builder's Guide
P. 69
TIP: More, larger format, colour pictures and the schematic & layout that are helpful in the build
are posted on the Trinity Forum – Resources Section. Right click on them to download if you
want print in large, colour format.
TIP: Sometimes it is hard to decode the resistors colours. It is a good idea to check the resistances
of these parts before assembly.
TIP: Use insulation tubes from the wiring on the resistor / cap leads around the tubes and pots by
using longer pieces of insulation stripped from the supplied 20 ga wire.
TIP: Heater Wires: Stranded wire is very hard to twist tightly. Stranded or solid doesn't make
much difference. Solid wire stays in place better once it's positioned and a bit easier to feed
through holes. If they aren't well twisted make sure they are tight against the chassis. Use 20 ga
solid for heaters. It is rated for more than 5A/600Volts.
TrinityAmps TRIWATT Builders Guide Ver. 2.31.docx
- 69 -
