Page 44 - Triwatt Custom Lead Amp Builder's Guide

3. At the other end, pull back the shield but poke a very fine screwdriver or pick into the
shield and work out a ‘hole’. Fish the inside conductor through this hole and pull it
through.
4. Twist the braid together.
5. Finally, cut back the outside plastic covering on the inside conductor at both ends by about
1/4"

Cliff Jacks - Cliff Jacks have 2 normally closed
contacts and 4 terminals. The contacts open when a
¼” plug is inserted into the jack. The Tip connection
is at the very end of the plug and is normally ‘positive’
polarity. This is sometimes referred to as the ‘Hot’
side. The other part of the plug is typically ground or
‘common’.

TrinityAmps TRIWATT Builders Guide Ver. 2.31.docx- 44 -